Support
- Total activity 990
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 939
Articles
Recent activity by Support-
What is the TPI of the blade supplied with a new PCB330BS Band Saw?
The Porter Cable Band Saw model PCB330Bs comes equipped with a blade that has 6 teeth per inch.
-
What type oil is used in the gearcase of a model 548 worm drive jig saw?
Use 90Wgear oil in the gearcase. Fill per instructions in your instruction manual.
-
How do I tighten the blade height adjustment? 3812 bench table saw
Please see the attached drawing. Tighten Ref. 112 against Ref. 111.
-
How is the laser on the 3700L powered?
The laser is powered by 3 AA batteries.
-
Where is the Porter Cable PXRA2676 Restorer sold?
The Porter Cable PXRA2676 Restorer can be found at Lowes, Amazon and Hartville Hardware.
-
What size spindle wrench is required to remove the pad on the Porter Cable right angle random orbit sanders and polishers?
The spindle wrench is a 9/16" open end. The service part number for this wrench is 692900.
-
What are the contents of the 12100 drum kit?
Note: The12100 Kit is replaced by kit part number 898194 . The kit includes 3/4", 1" and 1 1/2" sanding drums to accommodate varying radii. It also includes three adapter plates to use when mountin...
-
What is the maximum OPM (orbits per minute) of the pad while running, for RO sander models 332, 333, 333VS and 334?
The pads maximum speed is 12000 OPM.
-
What causes the sander to shake violently?
With age and use, the four rubber posts (that allow the pad to vibrate), can either become too stiff or too soft. If this has occurred, it will be necessary to replace those posts. A twisting ...
-
How fast should the pad on these sanders rotate?
The Controlled Finish System (pad brake), on these sanders should limit pad rotation to a maximum speed of 500 rpm while sanding. If the sander is run with the pad lifted off the work, pad rotation...