Support
- Total activity 990
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 939
Articles
Recent activity by Support-
What is the height of the 390K sander?
It is 4.5 inches tall.
-
What are the opm(orbits per minute)\rpms(revolutions per minute) of each speed on the 7424?
The speed dial increases the speed 700 opms\rpms for each setting from 1-6. Speeds: 1-2500 OPMs 2-3200 OPMs 3-3900 OPMs 4-4600 OPMs 5-5300 OPMs 6-6000 OPMs
-
What wrench do I use to adjust the clamping pressure of the PC890 Router?
Use a number T-27 Torx Wrench to adjust the lever clamping mechanism.
-
What is the distance from the bottom of the handles to the bottom of the sub-base?
The distance from bottom of handles to bottom of sub-base is .843" (27/32").
-
What should the pipe plug be torqued to?
Pipe Plug torque should be 35-40 inch lbs. Note: While Porter-Cable part number 859069 pipe plug is a standard pipe plug, you should only use the Porter-Cable part as part number 859069 pipe plug i...
-
Will the 890 router run on 50Hz?
No, the 890 will not run on 50Hz. While the motor is a universal motor and will operate on 50Hz, the remaining electronics must have 60 Hz.
-
What numbers do you call for the Porter Cable recalls?
Below are the numbers to call regarding the recent Porter Cable recalls.800-949-7930 Circular Saw Recall DNIS 2567800-949-6348 Router Recall DNIS 2568
-
My pressure washer works fine until I release the trigger and the engine bogs down and stops. What is causing this and how can I fix it?
For electric pressure washers this is normal operation and the motor should start up again once the trigger is engaged. If this is a gas powered pressure washer, then the pump is not going into by-...
-
How do I connect my generator to my house for emergency power?
Generators NOT equipped with a twist-lock receptacle will NOT be compatible for home installation purposes. A Double-Throw Transfer Switch will need to be installed by a licensed electrician. ...
-
How can I get parts and service for my Porter Cable product outside North America?
Porter-Cable products have been designed and approved for usage according to North American regulations. If you own such a product, you should refer to your source of purchase in order to obtain af...