Support

  • Total activity 1003
  • Last activity
  • Member since
  • Following 0 users
  • Followed by 0 users
  • Votes 0
  • Subscriptions 955

Activity overview

Latest activity by Support
  • Support created an article,

    What is the warranty for my PORTER CABLE tool?

      ONE YEAR LIMITED WARRANTY PORTER-CABLE industrial tools which state that they come with a one year limited warranty are warranted for one year from date of purchase. We will repair, without char...

  • Support created an article,

    Where can I find a service center to repair my tools?

    Looking for a service center to repair your tools? Please find the nearest authorized service center or factory-owned service center with the following LINK.  Just enter the requested information a...

  • Support created an article,

    What causes swirl marks?

    Swirl marks are usually caused by bits of aggregate separating from the sand paper and floating around under the pad. The loose aggregate has a tendency to work its way toward the center of the pad...

  • Support created an article,

    What can cause premature pad failure?

    Premature pad failure is often caused when excessive pressure is applied to the sander while sanding. Do not press down on the sander. Doing so decreases the sanders efficiency and will result in p...

  • Support created an article,

    What does the "LR" indicate in the 690LR model number?

    The "LR" stands for lever release.

  • Support created an article,

    What is the motor diameter of the Porter Cable 7815 router?

    The motor diameter for the 7815 is 4.2".

  • Support created an article,

    Can I use hot water in my pressure washer?

    All of our pressure washers are designed for cold water usage only. The temperature CAN NOT exceed 110 degrees. Doing so may damage internal components of the pump and void any warranty.

  • Support created an article,

    How many shots can one expect per fuel cell?

    There are approximately 3000 shots per fuel Cell.

  • Support created an article,

    What is the decibel rating of the model 7765 rotary hammer?

    The7765 is rated at a maximum average of 90 db. Note: Ear protection is recommended.

  • Support created an article,

    Can I put a 1/2" chuck on a 3/8" drill?

    No. The motors and transmissions are designed to handle a specific maximum load. Replacing a 3/8" chuck with a 1/2" chuck is not recommended. Make sure when you buy your replacement chuck that you ...